Description

BendPak XPR-10 Lift Series Equalizer Cables with 3/8 wire rope & 5/8 -11 Threads

SOME HAVE A THREAD ON ONE END AND A BUTTON ON THE OTHER AND SOME HAVE THREADS ON BOTH ENDS

• XPR-10A Uses two different length cables- Button on one end- 393.6″ 5595366, 398.25″ 5595358

• XPR-10AC Uses two different length cables– Button on one end- 352.5″ 5595034, 357″ 5595037

• XPR-10ACX Uses two different length cables- Button on one end- 366″ 5595012, 370″ 5595037

• XPR-10CX Button on one end – Uses two 368″ cables 5595009

• XPR-10C Button on one end – Uses two 356″ cables 5595016

IT IS RECOMMENDED THAT YOU MEASURE YOUR OLD CABLES TO VERIFY LENGTHS NEEDED

BendPak Equalizer 3/8-Inch-thick wire rope cable.

5/8 THREADED ON ONE END AND STUD ON OTHER END.  INSTALLATION TIP: The wire rope on the stud end gets slid through a slot on the back of one carriage, so the stud is in place on the carriage, the rest of the cable gets routed through the pulleys and the threads only, go into the hole on the opposite carriage and then the washer and nut are attached to threaded end. You don’t try to pull the entire cable through the hole on the carriage…

Cable has “Button” on one end and “Threads” on the opposite end.

CHOOSE THE CABLE YOU NEED OR ORDER BOTH SIZES FROM THE DROP-DOWN MENU